The use of this report is entirelyvoluntary, and its applicability and suitability for any particular use, including any patent infringement arising therefrom, is the sole responsibility of the user. SAE invites your written comments and suggestions. All rights reserved. Printed in U. This revision defines performancerequirements, dimensions, and designs for port and heavy-duty S series stud ends. Significant testing wasconducted to confirm the performance requirements of stud ends made from carbon steel.
|Published (Last):||14 May 2005|
|PDF File Size:||10.45 Mb|
|ePub File Size:||20.62 Mb|
|Price:||Free* [*Free Regsitration Required]|
A list of organizations represented on this subcommittee can be obtained on request to its secretary. This publication does not purport to include all the necessary provisions of a contract. Users are responsible for its correct application.
Compliance with a British Standard does not of itself confer immunity from legal obligations. Summary of pagesThis document comprises a front cover, an inside front cover, the ISO title page, pages ii to v, a blank page, pages 1 to 11 and a back cover. The BSI copyright notice displayed in this document indicates when the document was last issued. Amendments issued since publicationAmd. The work of preparing International Standards is normally carried out through ISO technical committees.
Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights.
ISO shall not be held responsible for identifying any or all such patent rights. This second edition cancels and replaces the first edition ISO , which has been technically revised. In general applications, a fluid liquid or gas may be conveyed under pressure.
Components are connected through their threaded ports by stud ends on fluid conductor connectors to tubes and pipes or to hose fittings and hoses. Stud ends in accordance with this part of ISO may be used at working pressures up to 63 MPa [ bar1 ] for non-adjustable stud ends and 40 MPa bar for adjustable stud ends.
The permissible working pressure depends upon the stud end size, materials, design, working conditions, application, etc. Conformance to the dimensional information in this part of ISO does not guarantee rated performance. Each manufacturer should perform testing according to the specification contained in this part of ISO to assure that components comply with the performance ratings. NOTE 1 A significant number of tests have been conducted to confirm the performance requirements of connection ends made from carbon steel.
See ISO for related hose fitting specification. NOTE 3 The Introduction of this part of ISO gives recommendations for ports and stud ends to be used for new designs in hydraulic fluid power applications. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document including any amendments applies.
ISO 6149-2 PDF